Description
This Multibeam Antenna contains Three Independent LTE Optimized Beams with 2×2 MIMO capability. It enables maximum spectrum re-use by sectorization, greatly increasing network capacity.
The LTE Optimized Beam Design approach provides fast roll off between beams, minimizing interference between sectors thus increasing the carrier to interference plus noise (CINR) ratio and lowering soft handover losses in LTE networks. Such an approach enhances data transfer rates within LTE network sectors and addresses “hotspots” in mobile wireless operator networks.
Technical Specifications
Electrical
Tech Specs - Electrical
| Interbeam Co-Pol Isolation (Adjacent Beams) |
> 25 dB |
| Lightning Protection |
DC Ground |
| Input Impedance |
50 ohms |
| Polarization |
Dual Pol 45º |
| Voltage Standing Wave Ratio (VSWR) |
< 1.5:1 |
| Ports |
6 x High Band Ports |
| Cross-Polar Port-to-Port Isolation |
> 25 dB |
| Front-to-Back Ratio @180º |
> 35 dB |
| Electrical Downtilt |
4º |
| Elevation Beamwidth (-3dB) |
5.4º |
| Azimuth Beamwidth (-3dB) |
17.6º |
| Gain |
22.3 dBi |
| Frequency Range |
3400-3800 MHz |
Mechanical
Tech Specs - Mechanical
| Front Wind Load |
99 lbs (440 N) @ 100 mph (161 kph) |
| Mounting Pole |
2” to 5” (5 cm to 12 cm) |
| Connector |
6 x 4.3-10 female |
| Side Wind Load |
53 lbs (237 N) @ 100 mph (161 kph) |
| Dimensions (L x W x D) |
35.6” x 12.9” x 6.3” (904 mm x 328 mm x 160 mm) |
| Weight |
22.5 lbs (10.2 kg)** |
| Survival Wind Speed |
Up to 150 mph (240 km/hr) |
*Electrical specifications follow document “Recommendation on Base Station Antenna Standards” (BASTA) V9.6.
**Weight excludes mounting
